I will have a plan for a large deep wooden tray with a handle. I plan on using a CNC
to cut out the tray and handle. The problem is that the handle needs to be about half
as high. The part I want to cut out is the bottom part of the handle.
My plan is too cut out the tray and handle then flip it over, and use a separate
gcode file created from the handle image (below) to shape the bottom of the handle.
This image is the handle, which I separated from the DSM project (further below) showing
the top view of the tray and handle. This is the image I need help with.
This is an image from the top view showing the handle and tray as one piece.
This image shows one of these trays which I made without a CNC. As you can see, the
handle is just a continuation of the tray, with shaping on the bottom of the handle.
This last image tries to show the part of the handle that needs removing.
I appreciate any instructions for how to change the shape of the DSM handle above.