
Jacant
- Activité totale 1022
- Dernière activité
- Membre depuis
- Abonné à 2 utilisateurs
- Abonnés 1 utilisateur
- Votes 16
- Abonnements 349
Aperçu des activités
Dernière activité effectuée par Jacant-
Jacant a ajouté un commentaire,
It will cut with the 1.43. Just make sure the cutter is perpendicular to the taper. You can download a Step file from here to check your thread. https://www.mcmaster.com/npt-threads%2fpipe-and-pipe...
-
Jacant a ajouté un commentaire,
Taper the hole to 1.8°.
-
Jacant a ajouté un commentaire,
And I just noticed that model has asymmetric teeth also! It depends on where you view it. I was convinced that the teeth where on a slant, with one edge more vertical than the other.
-
Jacant a ajouté un commentaire,
The second image is just a different STL file. You can select and delete any of the faces. Just use a crossing window right to left. Be careful it may select faces behind. As for the 'slider' I hav...
-
Jacant a ajouté un commentaire,
I had a look at that STL file you sent me. The only way to make it work would be to draw over the edges as shown with a Spline. Do this for the other end and Fill them. Blend using Splines taken fr...
-
Jacant a ajouté un commentaire,
Is the top gear surface directly above the bottom surface? Just looking at the image, they look to be offset. Is that correct? If they are in line, then why don't you use Freecad? It has a 'Gear Wo...
-
Jacant a ajouté un commentaire,
I smoothed the shape of the tooth by using a Spline. The solid cutter was pulled up and out by 0.1mm otherwise it will not cut. The outside and inside edges can easily be formed into smoother edges.
-
Jacant a ajouté un commentaire,
I'm pending approval. It's an air nozzle for a laser cutter. Same principle. Just remembered, you do have my email. Sure send it there.
-
Jacant a ajouté un commentaire,
I have done it before. You have to remember that an STL file is an approximation of the outside surface of a model. It is split up into facets, each facet will be split up again into triangles. The...
-
Jacant a ajouté un commentaire,
Excellent Job. Do you now have a consistent way to produce any size gear? Have you figured out how the central axle configuration will work and fit together, with all relevant bearings?