Aller au contenu principal

Bottom copper tracks and top copper ground plane


2 commentaires

  • Boss .

    Select the track routing icon, press shortcut "L" and you can select the layer you want to place the track on.

    Click on a rubber band/air wire (the yellow lines that show the net connections to pads) and start placing the track, left mouse click to place an anchor point and carry on.

    At a point you wish to change layer click and then press "L", the opposite layer for a two layer board will normally be preselected, so press enter to continue.

    When you place the components they are on the top layer, use "F" to flip them to the other side.

    DSPCB is always a top down view unlike Pro which can be a bottom view.

    Hope this helps.

  • John Orton

    Thanks for that Boss, it all makes sense now.


Vous devez vous connecter pour laisser un commentaire.