Editing or tweaking Faces
I would like to add curves etc to faces in the help index it has sections as follows:
Adding tweak control curves
You can add control curves to a face or surface when any editing method is active.
To add a control curve
1.Click Add Control Curve Closed in the Edit group on the FaceClosed Edit tab.
The Tweak Face tool must be active for this tab to be visible.
2.Click the point on the face or surface where you want to add the control curve.
You can use temporary geometry to help you find the point where you want to add a control curve.
Editing tweaked faces
You can think of the editing methods as modes. Different controls are displayed for each method, and these controls allow you to adjust the face or surface differently.
You can choose from the following methods:
Control points
Use this method when you want to change a face by moving its control points.
Control curves
Use this method when you want to change a face by changing its control curves.
BlendClosedClosed curves
Use this method when you want to change a face by changing its blend curves.
I am not able to find any of the control icons that the help index makes reference to, can any one help ?
-
Hi David,
Bad news: To my knowledge, there is no 'Tweak Face' tool within DSM. I've been using the 2.0 32 bit version from 2019 and V4 now V5, it hasn't been in any of those versions.
Looking back via youtube and the RS DSM 2013 release, Tweak Face icon tab isn't there either.
If you seriously need it, it's available within Ansys Spaceclaim which can be yearly rented for a similar cost to purchasing the perpetual Exchange ( very limited options) and Drawing bundle licences from RS.
0
Vous devez vous connecter pour laisser un commentaire.
Commentaires
1 commentaire