Blend Three Rings Into a Y fitting
Trying to get blend to make a Y fitting out of three solid circles. This might be a feature request?
-
An image would be good on the size, position and proximity of the three circles and the type of 'junction'
0 -
like the first one you did, but one hole is 12 inch and the other two are 6, how did you make it?
0 -
0
-
Mine does not have the clean join lines. I used planes on the end of a Y line, with circles that were sweeped to center of Y.
Hoping for the blend smoothness to create the same thing, but blend does not like to join 3.
0 -
It joins one just fine like this, but I want a Y fitting to split a 12 into two 6.
0 -
The simplest way is to use the cylinder tool:
Draw three lines in whichever Y configuration you want, return to 3D mode, select all 3 lines, click the cylinder tool and specify the diameter.
Et voila, It constructs the entire thing.
You can always add rounds afterwards:
0 -
Playing with it and this won't shell?
0 -
This will work, thanks.
0 -
Pull the Surfaces the opposite way to make Solids, so when you 'Blend' the two surfaces they will be 'Tangent' to each other. Pull/Blend one half. Move and copy 180°. Combine/Join. Shell. Pull line that joins the two 6" tubes.
0
Please sign in to leave a comment.
Comments
9 comments