Zum Hauptinhalt gehen

ground fill isolation gap?

Kommentare

3 Kommentare

  • Boss .

    They posted a fix for this on the old forum. Contact support and they send you an updated dll which fixes this. I installed it and it worked.

    0
  • Boss .

    Thinking further, the above was for pads connected to the pour i.e. for thermal isolation. You may be asking a more general question relating to pouring copper?

    For general gaps see the image. A copper pour is a 'shape' and you control the clearances in the Design Technology use Shift+T short
    cut and select spacing tab. The setting are obviously done before the pour.

    1
  • Igor Nikolaevich

    Thank you very-very much!

    0

Bitte melden Sie sich an, um einen Kommentar zu hinterlassen.